Allied Vision Alvium G1 - Mounting G1 Housed Cameras

Installing the camera
179Alvium G1 User Guide V1.7.0
Mounting G1 housed cameras
Top and bottom mounting
Especially for dynamic applications with high acceleration, mount the camera using
the bottom mounting threads in addition.
The maximum torque value applies only if the entire thread engagement is
used. For other values, see Adapting maximum torque values on page 181. For
technical drawings, see G1 Closed Housing: Dimensions and mass on page 143.
1. As shown in Figure 55, mount the camera to the base using suitable M3 screws
for mounting thread a: At 0.51 Nm maximum torque for a thread engagement
(C) of 2.2 mm between screws and mounting threads.
2. For Alvium G1 BL housed cameras, continue with Mounting the G1 BL interface
unit on page 184
Instructions by Alvium G1 hardware option
•
Standard Alvium G1 Closed Housing Mounting G1 housed cameras on page 179
Alvium G1 BL cameras with mount Mounting G1 housed cameras on page 179
Mounting G1 BL cameras with mount on page 180
Mounting the G1 BL interface unit on page 184
Alvium G1 BL No Mount Mounting G1 BL No Mount cameras on page 182
Mounting the G1 BL interface unit on page 184
Figure 55: Mounting threads bottom and top (a)
13
±0.1
20
±0.1
M3 - 2.5 (2x)
41.3
c
c
Detail c: DϯљϮϮљϰϬ
сDϯсϬϯсϮϮсϰϬ
D
B
C
A