Installing the camera
184Alvium G1 User Guide V1.7.0
Mounting the G1 BL interface unit
After mounting the Alvium G1 BL sensor unit according to Mounting G1 BL
cameras with mount on page 180 or Mounting G1 BL No Mount cameras on page
182, the interface unit must be mounted and connected as shown in this section.
1. Using 4 compatible M3 screws (i), mount the interface unit to the mounting
base, as shown in Figure 60 below.
NOTICE
Damage to the camera
The interface unit does not allow disassembly by the user.
• Keep the interface unit assembled.
• Do not remove the mounting plate from the interface unit.
Heat dissipation
Use a metal base with a large surface area and a thermal pad for the cooling area
(blue area in Figure 60), to ensure optimum heat dissipation for the interface board.
See also Cooling area for the Alvium G1 BL sensor unit on page 178.
Figure 60: Mounting the G1 BL interface unit to the base
i i ii
Thermal pad
Interface unit
Mounting base
Cooling area
Mounting plate
To Next Page
Loading...
