Camera interfaces
206Alvium G1 User Guide V1.7.0
Status LEDs
Alvium G1 cameras have LEDs to signal in yellow, green, or red color.
LED codes
Error state
If the camera signals an error, try the following to get the camera back to normal
operation:
• Restart the camera.
• Should this fail, please contact support at www.alliedvision.com/en/about-us/
contact-us/technical-support-repair-/-rma.
LED settings
You can define LED settings with the
DeviceIndicatorLuminance feature:
• A value of 10 enables LED signaling at the highest luminance level.
• Values below 10 reduce the luminance level.
• 0 disables LED signaling.
LED codes Behavior Status
Continuously active Camera is initializing
1 flash per second Camera is operational
Continuously active Error state
Table 110: LED codes
Yellow LED color
With yellow, a green and a red LED are active in parallel. Seen directly from behind,
this appears as yellow; seen from an angle, you can see green and red separately.
To Next Page
Loading...
