Installing the camera
183Alvium G1 User Guide V1.7.0
Schematic drawings in Figure 59 show the Alvium G1 BL No Mount camera. Only
the mounting area (gray) can be used for mounting. The sensor and electronics
area (red) must not be touched nor put at mechanical stress.
g = Mounting hole | h = Mounting hole and chassis ground
Mount the No Mount camera with four M1.6 screws at 0.1 Nm maximum torque.
NOTICE
Damage to the camera by improper mounting
• Allow mechanical contact only at the mounting area.
• Avoid any mechanical stress to the sensor and the electronics area.
• Avoid short circuits of the electronics components.
• Give 2 mm minimum clearance above board components.
• Tighten screws at 0.1 Nm maximum torque.
Figure 59: Mounting area of Alvium G1 BL No Mount cameras
connector side (left); sensor side (right)
Top
g h
gg
h g
g g
To Next Page
Loading...
