Specifications
83Alvium G1 User Guide V1.7.0
ROI frame rates
Values are based on the conditions defined in Specified values on page 53. To
reach the maximum frame rate available for typical operation, the bandwidth for
image traffic is 99 MByte/s. Increasing the
DeviceLinkThroughputLimit value
does not increase frame rates.
Image format
Width
[pixels]
Height
[pixels]
ROI area
[MP]
Frame rate [fps]
1
122 MByte/s 12 MByte/s
Full resolution 1936 1216 2,354 40.4/24.8 4.9/2.4
Full HD 1920 1080 2,074 45.3/28.0 5.5/2.8
UXGA 1600 1200 1,920 41.0/30.4 6.0/3.0
WXGA+ 1440 900 1,296 53.9/42.0 8.8/4.4
SXGA 1280 1024 1,311 47.7/37.2 8.8/4.4
HD 720 1280 720 0.922 66.5/51.8 12.3/6.2
XGA 1024 768 0.786 62.7/48.8 14.4/7.2
SVGA 800 600 0.480 79.0/61.6 23.3/11.7
VGA 640 480 0.307 96.9/75.5 35.7/18.0
HVGA 480 320 0.154 139.2/108.5 68.3/34.4
QVGA 320 240 0.077 177.7/138.5 131.2/66.0
HQVGA 240 160 0.038 245.8/191.6 240.8/121.6
QQVGA 160 120 0.019 305.8/238.3 305.8/225.9
Max. × half 1936 608 1,177 77.6/47.7 9.5/4.7
Max. × min. 1936 8 0.015 828.7/524.8 111.6/56.1
Min. × max. 8 1216 0.010 40.6/40.6/31.6
Min. × min. 8 8 64 P 917.5/917.5/715.1
1
Mono8 or Mono10, or Bayer...8
(2)
or Bayer...10 at SensorBitDepth = 10-Bit
(3)
/
Mono12 or Bayer...12 at
SensorBitDepth = 12-Bit
2
The three dots... represent the colors of a Bayer pixel format, such as in BayerRG8.
3
The SensorBitDepth value must be set separately from PixelFormat.
See Sensor ADC readout modes for maximum frame rates on page 54 for details.
Table 31: Alvium G1-234m/c ROI frame rates
To Next Page
Loading...
