Safety
Opus Operator's Manual 2-3
2.3.1 Precautions
• Physicians, clinicians and practitioners should read this manual thoroughly
before attempting to operate the system.
• Applicators and applicator tips must be kept clean at all times.
• The system is well balanced and is designed to be moved, but should always
be moved carefully and slowly. Never pull the system by the applicator.
• The system needs special precautions regarding EMC and needs to be installed
and put into service according to the EMC information provided in the
accompanying documents.
2.3.2 Cautions
• Only Alma Lasers authorized personnel may service the system. This includes
making internal adjustments to the power supply, applicators, etc.
• Maintenance performed by the operator must only take place when the system
is shut down and disconnected from the electrical power source. Performing
maintenance procedures with the system powered-up can be hazardous to the
operator and/or destructive to the system.
• Always turn off the system when it is not in use.
• Never leave the system in Ready mode unattended.
• Never allow untrained personnel to operate the system.
• Never press the trigger and/or footswitch unless the applicator is safely
oriented at a specific and intended target.
• The applicators and tips must always be visually inspected before treating the
patient. If any wear or damage is apparent, do not use the applicator.
• Never leave the system turned on, open or unattended during system
maintenance.
2.3.3 Burn Hazards
The system emits RF energy that can damage the skin in cases of using excessive
power levels.
2.3.4 Explosion and Fire Hazards
• The system is not suitable for use in the presence of flammable mixtures with
air or oxygen.
• Do not operate in the presence of volatile solvents such as alcohol, gasoline or
other solvents.
• Do not use any flammable substances such as alcohol or acetone in the
preparation of the skin for treatment. If necessary, use soap and water to clean
before treatment.
• If alcohol is used to clean and disinfect any part of the system, allow it to dry
thoroughly before operating the system.
• Flammable materials must be kept at a safe distance from the system.
To Next Page
Loading...