Alma Opus - Aconnecting the Footswitch; Storage and Transportation; Moving the System; Environmental Conditions During Transportation

Installation
3-4 Opus Operator's Manual
3.5 Connecting the Footswitch
The footswitch supplied with the system is pneumatically operated.
To connect the footswitch, connect the footswitch's black tube to the connection
port on the system's service panel.
Figure 3-4: Footswitch Connection Port
3.6 Storage and Transportation
3.6.1 Moving the System
To move the system around the floor, ensure that the connected applicator is safely
stored in its cradle; then the system can be rolled around the room on the wheeled
cart.
Carrying the system up or down the stairs should be done by two people, one
carrying the system, and the other carrying the cart.
To transport the system to another location:
1. Disconnect the applicator and store it in its dedicated carrying case.
2. Disconnect the power cable.
3. Disconnect the footswitch's air tube.
4. Pack the system and cart in their original shipping boxes and insert the
foam braces to protect them.
At the new location:
5. Reconnect the footswitch and the power cable.
6. Connect the applicator and resume normal operation.
Caution
Never use the applicator or umbilical cable to move the system.
3.6.2 Environmental Conditions during Transportation
Transportation of the system should be under normal environmental conditions
within the following range:
• Ambient temperature: 20 to 25ºC
• Relative air humidity: less than 80%
• Atmospheric pressure: 90 to 110 kPa