Operating Instructions
6-2 Opus Operator's Manual
6.4 Operate the System
6.4.1 Turn on the System
To turn on the system:
1. Verify that the emergency shut-off knob is not pressed in. If it is, release it
by turning the knob clockwise; the knob pops out.
2. From the system rear panel, set the main power switch to the I (On)
position;
• The Keyswitch Off screen appears on the display (see Figure 6-1)
Figure 6-1: Keyswitch Off Screen
Note
• The Keyswitch Off screen appears when the keyswitch is turned off.
• The speaker button toggles the system's buzzer to On or Off modes.
3. Turn on the keyswitch;
• The system powers up.
Refer to applicator chapter for further instruction and applicator operation.