Chapter II Installation and Wiring
15
GB/T17626.2-6. In order to avoid any possible influence of external strong
electromagnetic interference source, to ensure normal operation of the servo system,
and to prevent the adverse impacts of the actions of the high -frequency electronic
switch on the sensitive equipment nearby, the following EMC measures should be
taken during the installation of the servo system:
Install the servo drive in a shield box;
Ensure that the servo drive and the servo motor are reliably grounded;
The input and output signal cables shall be shielded twisted pair, and ferrite beads
(winding two coils) shall be used;
The encoder cables shall be shielded twisted pair, and ferrite beads (winding one
coil) shall be used;
The main circuit cables shall be shielded cables if possible, and the shielding layer
shall be reliably grounded.
2.5 Main Circuit Terminal Wiring
Fig. 2-2 Main Circuit Terminal Interface
To Next Page
