Alpha AS100 Series - Auxiliary Operation (Group P01)

Chapter VI Specified Function Introduction
89
parameters have been written to EEPROM. The system will use factory set values after
being powered up again.
2: Start the operation of save the overall parameters into EEPROM. During this
operation, all the parameters currently kept in RAM will be written to EEPROM for
saving.
6.2 Auxiliary Operation (Group P01)
Function
Code
Parameter Name
Attribute
Setting
Range
Unit
Factory
Defaults
P01.00
Speed trial operation
function
Immediately
effective
-
-
0
Function Description
Enter this parameter and press button, then you can access into the speed
commissioning interface. The servo drive will settle into forced enabled state and the
servo motor is powered. Refer to Section 4.1.3 for detailed operation.
Function
Code
Parameter Name
Attribute
Setting
Range
Unit
Factory
Defaults
P01.01
JOG trial operation
function
Immediately
effective
-
-
0
Function Description:
Enter this parameter and press button, then you can access into the JOG
commissioning interface. The servo drive will settle into forced enabled state and the
servo motor is powered. Refer to Section 4.1.3 for detailed operation.
The rotate speed command of JOG commissioning is set by parameter P05.01.
Function
Code
Parameter Name
Attribute
Setting
Range
Unit
Factory
Defaults
P01.02
Limit value of
software over
current
Immediately
effective
0~900
0.1A
--