Amazone AmaLog+ - Displaying; altering the working width; Displaying; altering the target blower fan speed (during standstill)

Settings
AMALOG BAH0017.6 08.19
25
6.2 Displaying / altering the working width
1. Press .
 Display:
stored working width [m],
e.g. 3.0 m (Fig. 15).
2. Change the working width [m]
with the
and buttons.
3. Press
.
 Store the selected value.
Fig. 15
6.3 Displaying / altering the target blower fan speed (during standstill)
This setting is only possible for pneumatic seed
drills.
1. Press the
button (yellow).
 Display: Target blower fan speed [rpm.].
2. Change the target blower fan speed with
the
and buttons.
3. Press
.
 Store the selected value.
Fig. 16
Switch off the blower fan speed monitoring
Set the target blower fan speed to "0".