Amazone AmaLog+ - Tables: calibration values; crank turns (guide values)

Tables
40
AMALOG BAH0017.6 08.19
9.3 Tables: calibration values / crank turns (guide values)
The table values in the Chapter are guide values.
If the actual calibration value (imp./100 m) deviates from the table
value, the number of crank turns for the calibration test will also
change.
You can enter your determined calibration values in the table (Fig.
39).
Mechanical seeding technology
Mounted seed drills
D9 Super / Special
Working width 2.5 m 3.0 m 3.5 m 4.0 m 6.0 m
Tyres
Calibration value
(imp./100 m)
Crank turns on 1/40 ha
6.00 – 16
180/90 – 16
740
46.0 38.5 33.0
 
10.0/75 - 15
711
  
28.0 18.5
Towed
seed drills
Working width 6.0 m
Calibration value
(imp./100 m)
Crank turns
on 1/40 ha
D9 6000 TC
648 17.0
Pack top seed drills
(mechanical)
Working width
2.5 m 3.0 m 3.5 m 4.0 m
Calibration value
(imp./100 m) Crank turns on 1/40 ha
AD 25/3000 Special
AD 30/35/4000 Super
617 27.0 22.5 19.0 17.0
Pack top seed drill
Cataya 3000 Special
with star wheel drive
Working width
3.0 m
Roller chain
hooked on at
Calibration value
(imp./100 m)
Crank turns
on 1/40 ha
Z = 16
291 18
Z = 34
618 18
Z = 50
909 18