Version 1.4 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 34
digital thermometers are not a good source and have their own margin of error.
Place the sensor in a shaded, controlled environment next to the fluid thermometer, and allow the sensor to
stabilize for 48 hours. Compare this temperature to the fluid thermometer and adjust the console to match the
fluid thermometer.
Indoor Sensor Installation
Indoor use only. It is recommended you mount the Indoor sensor in a shaded area. Avoid indirect
sunlight and radiant heat sources that will result in inaccurate temperature readings. Use a screw or
nail (not included) to affix the indoor sensor to the wall, as shown in Figure 46.
Figure 46
To place on a table or horizontal surface, fold out the desk stand, as shown in Figure 47.
To Next Page
Loading...
Need help?
General
