Version 1.4 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 51
Rainfall (1h) high alarm
Rainfall (24h) high alarm
Absolute pressure high alarm
Absolute pressure low alarm
Relative pressure high alarm
Relative pressure low alarm
Indoor temperature high alarm
Indoor temperature low alarm
Indoor humidity high alarm
Indoor humidity low alarm
Alarm and Command Button Beeper ON/OFF Mode
The beeper can be silenced for both alarms and button strokes.
In normal mode, press and hold the ALARM button for three seconds to toggle the beeper on or off
(depending on the current setting).
The BUZZ ON (beeper on) or BUZZ OFF (beeper off) icon will appear in the time area for three seconds.
Press and hold the ALARM button again for three seconds to toggle the BUZZ ON or BUZZ OFF.
Wi-Fi Connection Status
When the console successfully connects to your Wi-Fi router, the Wi-Fi signal icon will appear on
the LCD display (in front of the indoor temperature). If the Wi-Fi signal is not stable or the console is trying
to connect to the router, the icon will flash. If the icon disappears, it means the console is not connected to
the Wi-Fi router.
Note: If you own a dual band router (2.4 GHz and 5.0 GHz), make sure you connect to the 2.4 GHz band,
otherwise it will fail to connect the weather station to Wi-Fi.
Time Server Sync Status
After the console has connected to the internet, it will attempt to connect to the USA's NIST internet time
server to obtain the time. Once the connection succeeds and the console's time has updated, the SYNC icon
will appear on the LCD. The time will automatically synchronize to the internet per an hour.
Wi-Fi and Internet Services
IMPORTANT NOTE: Make sure the console is plugged into AC power. It will not connect to Wi-Fi
otherwise.