Version 1.4 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 44
Restore Factory Default
To restore the console to factory default (Wi-Fi network, Weather server and display):
Remove the batteries
Press and hold the MIN/MAX/- button and put the batteries back in.
Wait three seconds after installing the batteries to let go of the MIN/MAX/- button.
Snooze Mode
When the alarm sounds and alarm icon flashes, tap the SNOOZE/LIGHT button to temporarily silence
the alarm for five minutes.
The snooze icon will continue to flash, and after five minutes, the alarm will sound again. This will
continue until the alarm is turned off. Touch any button (SET, Min/Max/-,CHANNEL/+) to permanently exit
the Snooze mode.
Back light Mode
If the LED is off, press the LIGHT button once. The backlight will turn on for five seconds, and if no
operation is performed for three seconds, the backlight will turn off.
Press and hold the SNOOZE/LIGHT button for two seconds, and the backlight will turn on permanently,
and display BL ON icon will be displayed for three seconds in the time field.
To turn off the backlight at any time, Press and hold the SNOOZE/LIGHT button for two seconds, and BL
OFF icon will be displayed for three seconds in the date field.
Note: If plugged into AC power, the time area will display AC ON, and the backlight will remain on. It is
not recommended leaving the backlight on for a long period of time when operating on batteries only, or the
batteries will run down quickly.
RF Signal Quality
The RF signal quality icon will appear next to the measured parameter.
To Next Page
Loading...
Need help?
General
