Version 1.4 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 9
Hammer and nail for hanging remote thermo-hygrometer transmitter.
Sensor Assembly and Installation
Anemometer
Anemometer Assembly
The anemometer assembly consists of the wind cups, wind vane, solar panel, bubble level, sensor mounting
bracket and mounting foot. The solar panel provides power to the anemometer when the sun is out, and the
batteries provide power at night (the solar panel does not charge the batteries).
Figure 10
Locate the battery door on the anemometer transmitter, push and open the battery compartment, as shown in
Figure 11.