Ametek Land LANCOM 4 - Connecting the Battery

3 - 1
Lancom 4Portable Flue Gas Analyser
User Guide
3 Preparing the Lancom 4 for use
3.1 Connecting the Battery
CAUTION
Do not short-circuit the battery terminals.
1) Unscrew the side panel screws and
remove both instrument side panels.
2) Remove the insulating sheaths from the
battery terminals. DO NOT throw away
the sheaths. They must be kept for use
in the event the instrument has to be
returned to Land for servicing.
3) Fit the red battery wires to the positive
terminals.
4) Rettheinstrumentsidepanels.
5) Connect the power supply and ensure
thechargeLEDashes,thenafterafew
seconds is lit continuously.
6) Switch the instrument ON
7) Leave the instrument to charge fully.
Side panel screws
Due to shipping regulations, your
instrument has been shipped with
the batteries disconnected.
Please follow the instructions gi
Please follow the instructions given
in the User Guide to reconnect the
batteries and prepare the instrument
for use.
WARNING
Batteries
Battery terminals