105446 06 23-03-2009 81
Nominal values Accepted range
RTD and Reference Inputs:
50Ω (45 to 70Ω)
176Ω (150 to 200Ω)
345Ω (330 to 350Ω)
RTD inputs:
1000Ω (800 to 1200Ω)
2700Ω (2300 to 2900Ω)
mA inputs:
0 mA (-1 to +1 mA)
10 mA (9 to 11 mA)
20 mA (18 to 22 mA)
V Inputs:
0 V (-1 to +1 V)
5 V (3 to 7 V)
10 V (9 to 11 V)
mV inputs:
0 mV (-1 to +1 mV)
35 mV (25 to 45 mV)
70 mV (63 to 77 mV)
Cold Junction compensation: N-type thermocouple and a
reference junction, for example an
ice bath.
Note that Cold Junction compensation is only possible when
”Measure/Adjust/Calibrate” is selected.
The number and type of electrical inputs to be checked is user-
definable. You can also define if you want to check the inputs by just
measuring them or to measure, adjust and then calibrate the electrical
inputs.
Cold Junction compensation requires a special setup, using a
calibrated temperature source, for example an ice bath. This and the
measurement principles are shown briefly below:
To Next Page
Loading...
