Ametek Sorensen DHP Series - Table 1-3 Available Voltages and Currents

Table 1-3
Available Voltages and Currents
V Out
2KW 3KW 5KW 6.6KW 10KW 15KW 13.3KW 16.6KW 20KW 25KW 30KW
5 325 1000 1500 2000 2500 3000
8 250 350 800 1200
1600 2000 2400
10 200 300 660 1000 1300 1650 2000
12.5 530 800 1060 1325 1600
15 130 200 440 660 880 1100 1320
20 100 150 330 500 665 830 1000
25 265 400 520 650 800
30 66 100 220 330 440 550 660
40 50 75 166 250 330 415 500
50 40 60 133 200 265 330 400
60 33 50 110 166 220 275 330
80 25 37 62 125 187 250 312 375
100 20 30 50 100 150 200 250 300
120 16 25
130 38 76 115 153 192 230
150 13 20 33 66 100 133 166 200
200 10 15 25 50 75 100 125 150
2508 1220 4060 80100120
3006.61016 3350 6683100
400 5 7.5 12 25 37 50 62 75
600 11 16 22 27 33
Notes:
-
Basic model number includes
voltage and current from
from table, e.g.
- 600 volt models are not CE
marked or UL listed.
P-P
30 mV
2U HEIGHT
Output Ripple - Typical
20-60V
80V
45 mV
100 mV
15 mV
25 mV
RMS
10-15 mV
600V
125 mV
135 mV
150 mV
175 mV
200 mV
225 mV
2 V
100V
120V
250 mV
25 mV
25 mV
25 mV
25 mV
3U HEIGHT 6U HEIGHT
25 mV
25 mV
250-300V
400V
150V
200V
RATING
5-15V
DHP5-325
VOLTS CURRENT
***
* P-P noise is measured across a 1 uF capacitor at the end of a 6’ load cable
with the supply operating at full load and at nominal input line voltage.
** RMS noise is measured directly across the output terminals with the supply
operating at full load and at nominal input linevoltage.
M550004-01
1-6