Table 1-2
5kW to 15kW and 16kW to 30kW Series Technical Characteristics
PARAMETERS
SPECIFICATIONS
PHYSICAL CHARACTERISTICS
Width
Depth
Height
Weight
ELECTRICAL CHARACTERISTICS
Input Power
Voltage
Standard
Options
Frequency
Phases
Regulation (Line or Load)
Voltage
Current
Transient Response
Stability
Remote Control/Monitor
Power Density
Power Factor
Efficiency
≤60V to 10kW ≤60V to 20kW
≥80V to 15kW ≥80V to 30kW
600V to 10kW 600V to 20kW
19.00 in. 19.00 in.
22.00 in. 22.00 in.
(output connections not included)
5.25 in. 10.5 in.
120 lbs. max. 163 lbs. max.
208-230 VAC (tested to 190-253 VAC)
400 VAC (tested to 360-440 VAC)
480 VAC (tested to 432-528 VAC)
47 to 63 Hz
3-phase, 3-wire plus ground
0.1% of max. output voltage
0.1% of max. output current for 80V and higher
0.5% of max. output current for <80V
A 30% step load will recover to within 2% of
original value within 10ms.
+0.05% of set point after 8 hr. warm-up
at fixed line, load and temp.
On/Off control via contact closure, 6-120
VDC or 12-120 VAC, and TTL or CMOS
switch, output voltage and current monitor,
OVP limit set, summary fault status.
4.5 Watts/cubic in. (10 & 20 KW)
6.8 Watts/cubic in. (15 & 30 KW)
.72 min.
80% minimum at full load
M550004-01
1-4
To Next Page
Loading...
