User Manual
_________________________________________________________________
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com 19
CAU
TION
Before connecting a battery cabinet to the UPS, the circuit breaker of the
battery pack must be switched to “OFF”. After electrical connection with
the UPS is established, the breaker must be switched to “ON”.
NOTE:
Each battery
cabinet contains
two battery
connectors.
The
first
bat
tery cabinet is connected to the UPS using the cable
supplied with the cabinet. Each additional extension battery cabinet
is connected by
attaching
its cable to the
previous cabinet.
Refer to the figure
on
the next page.
If additional battery cabinets (up to 4) are to be used, they should be
connected prior to connecting the UPS to the input power. To connect
external battery cabinets, follow the steps below:
1. Set the circuit breaker to the “OFF” position.
2. Remove the battery connector cover from the UPS.
3. Remove the battery connector cover from the extended battery
cabinet.
4. If there are multiple extended batter cabinets, remove the addition-
al battery connector covers. If not, proceed to Step 5.
5. Connect the supplied battery cable to the extended battery cabinet.
6. Connect the other end of the battery cable to the UPS.
7. For multiple extended battery cabinets, connect the supplied bat-
tery
cables as
shown in the figure
below
.
8. Set the circuit breaker to the “ON” position.
To Next Page
Loading...
Need help?
General
