User Manual
_________________________________________________________________
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com 21
4. SETTING UP UPS PARAMETERS
4.1 Factory Default Settings
The UPS is shipped with the following default factory settings. Refer to
the table below and also to the table “LCD Display Abbreviation Index”.
Programmable Outlets Backup Time Setting
LCD Display Direction Setting
Acceptable Input Voltage Range Setting
Number of External Battery Cabinets
If the factory default settings are acceptable, proceed directly to Section
“UPS OPERATION”. To change any of the default settings proceed
directly to Section 4.0 “Changing Default Settings”.
4.2 Changing Default Settings
Plug the input of the UPS into a two-pole, three-wire, grounded recep-
tacle. Avoid using extension cords. If the mains voltage is within the
acceptable range, the UPS will enter bypass mode. “BYPASS” will be
displayed in the UPS status window on the LCD display.
To Next Page
Loading...
Need help?
General
