Ametek Thermox WDG-VCM User Manual

6-18 | Thermox WDG-V / VC / VCM with Blow Back
Electronics Replacement
Electronics Replacement
Use Figure 8-9:
1. Disconnect all wires.
2. Loosen the two Phillips screw located on the back of the electronics
plate.
3. Slide the board out until the pegs at the top line up with the holes in
the electronics board plate and drop it down.
4. Replace the electronics board.
5. Properly tighten the screws.

Ametek Thermox WDG-VCM Specifications

General

Brand	Ametek
Model	Thermox WDG-VCM
Category	Measuring Instruments
Language	English