GENIE
®
II Mk2/ eazyReport
TM
software
5
While every effort has been made to protect the inside of the device against splashes,
the device carries no IP rating. If fluids are spilt on the device they may cause damage
and cause an electrical hazard.
If a spill occurs, remove power from the device. Do not touch the device or any fluid
flowing from it while it is connected to the mains supply. Always follow local health and
safety guidelines.
Genie
®
II Mk2 is disconnected by removal of incoming mains power source to the unit.
Following disconnection the unit should be left for a period of at least 5 minutes before
any internal assemblies are removed or examined.
When in use the heating blocks and heated lids are hot, so allow to cool before
touching the surfaces.
Safe removal of fluids from Genie
®
II Mk2 will depend on the chemistry used. This will also
require knowledge of the fluids used in the system to adhere with local health and safety
and COSHH regulations. If in doubt, consult the person responsible for the equipment in the
laboratory.
To Next Page
Loading...