Setup and Configuration
36
Tango Series Audio Controllers
You may need to modify your programming technique on a remote-by-remote basis. Some
remotes may need to be closer to or further away from the receiver. Some may program better
with quick key presses and some with long key presses. Some may require a change in distance
and angle between the remote and the Tango Controller. If a particular method doesn’t seem
to be working for you, try to modify your approach to understand the characteristic behavior
of the donor device.
Programming the Tango Controller
The Programming Panel
The IR learning programming controls are located on the front of the Tango Controller. FIG. 23 shows
the front of the Tango Controller with the navigation array to the left of the readout. The array is used to
navigate through the programming and setup of the Controller.
Main Menu screen
Press the center navigation button on the front of the Controller to access the Main Menu screen
(FIG. 24).
FIG. 23 IR learning programming controls
FIG. 24 Main Menu screen options
Press the center button (Select) to access the Main Menu:
Nav Up
Nav Down
Nav Right
Nav Left
Select
Exits this screen
To th e About screens
To th e Backlight Options screens
To th e System Setup Mode scree
Use the navigation buttons (<< / >>) on the front of the Controller to move from one
option to another, and the SELECT button to make a selection.
To Next Page
Loading...
