Programming the Mio R-4
Page Commands (Cont.)
@PST Set the show effect time for the specified popup page.
Syntax:
SEND_COMMAND <DEV>,"'@PST-<popup page name>;<show effect time>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
• show effect time = Given in 1/10ths of a second.
Example:
SEND_COMMAND Device,"'@PST-Popup1;50'"
Sets the Popup1 show effect time to 5 seconds.
PPOF Deactivate a specific popup page on either a specified page or the current page. If the page name is empty, the
current page is used (see example 2). If the popup page is part of a group, the whole group is deactivated. This
command works in the same way as the 'Hide Popup' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'PPOF-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the popup page.
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'PPOF-Popup1;Main'"
Deactivates the popup page 'Popup1' on the Main page.
Example 2:
SEND_COMMAND Device,"'PPOF-Popup1'"
Deactivates the popup page 'Popup1' on the current page.
PPOG Toggle a specific popup page on either a specified page or the current page. If the page name is empty, the
current page is used (see example 2). Toggling refers to the activating/deactivating (On/Off) of a popup page.
This command works in the same way as the 'Toggle Popup' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'PPOG-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the popup page.
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'PPOG-Popup1;Main'"
Toggles the popup page 'Popup1' on the Main page from one state to another (On/Off).
Example 2:
SEND_COMMAND Device,"'PPOG-Popup1'"
Toggles the popup page 'Popup1' on the current page from one state to another (On/Off).
PPON Activate a specific popup page to launch on either a specified page or the current page. If the page name is
empty, the current page is used (see example 2). If the popup page is already On, do not re-draw it. This
command works in the same way as the 'Show Popup' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'PPON-<popup page name>;<page name>'"
Variable:
• popup page name = 1 - 50 ASCII characters. Name of the popup page.
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'PPON-Popup1;Main'"
Activates the popup page 'Popup1' on the Main page.
Example 2:
SEND_COMMAND Device,"'PPON-Popup1'"
Activates the popup page 'Popup1' on the current page.
To Next Page
Loading...
