Programming the Mio R-4
"^" Button Commands (Cont.)
^BSF Set the focus to the text area.
Note: Select one button at a time (single variable text address). Do not assign a variable text address range to
set focus to multiple buttons. Only one variable text address can be in focus at a time.
Syntax:
"'^BSF-<vt addr range>,<selection value>'"
Variable:
• variable text address range = 1 - 4000.
• selection value = Unselect = 0 and select = 1.
Example:
SEND_COMMAND Device,"'^BSF-500,1'"
Sets the focus to the text area of the button.
^BSM This command causes the text areas to send their text as strings to the NetLinx Master.
Syntax:
"'^BSM-<vt addr range>'"
Variable:
• variable text address range = 1 - 4000.
Example:
SEND_COMMAND Device,"'^BSM-500'"
Submits the text of the text area button.
^BSP Set the button size and its position on the page.
Syntax:
"'^BSP-<vt addr range>,<left>,<top>,<right>,<bottom>'"
Variable:
• variable text address range = 1 - 4000.
• left = left side of page.
• top = top of page.
• right = right side of page.
• bottom = bottom of page.
Example:
SEND_COMMAND Device,"'^BSP-530,left,top'"
Sets the button with variable text 530 in the left side top of page.
^BWW Set the button word wrap feature to those buttons with a defined address range. By default, word-wrap is Off.
Syntax:
"'^BWW-<vt addr range>,<button states range>,<word wrap>'"
Variable:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and
2 = On state).
• word wrap = (0=Off and 1=On). Default is Off.
Example:
SEND_COMMAND Device,"'^BWW-500,1,1'"
Sets the word wrap on for the button’s Off state.
^CPF Clear all page flips from a button.
Syntax:
"'^CPF-<vt addr range>'"
Variables:
• variable text address range = 1 - 4000.
Example:
SEND_COMMAND Remote,"'^CPF-500'"
Clears all page flips from the button.
To Next Page
Loading...
