AMX MIO-R4 - Project Migration (from previous versions of TPDesign4); Using the TPD Conversion Wizard

Programming the Mio R-4
47
Mio Modero R-4 Remote
"^" Button Commands (Cont.)
^BMP Assign a picture to those buttons with a defined address range.
Syntax:
"'^BMP-<vt addr range>,<button states range>,<name of bitmap/picture>'"
Variable:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and
2 = On state).
• name of bitmap/picture = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Device,"'^BMP-500.504&510.515,1,bitmap.png'"
Sets the OFF state picture for the buttons with variable text ranges of 500-504 & 510-515.
^BOR Set a border to a specific border style associated with a border value for those buttons with a defined address
range.
Syntax:
"'^BOR-<vt addr range>,<border style name or border value>'"
Variable:
• variable text address range = 1 - 4000.
• border style name = Refer to theBorder Styles by Numbers table on page 33.
• border value = 0 - 41.
Examples:
SEND_COMMAND Device,"'^BOR-500.504&510.515,10'"
Sets the border by number (#10) to those buttons with the variable text range of 500-504 & 510-515.
SEND_COMMAND Device,"'^BOR-500.504&510,AMX Elite -M'"
Sets the border by name (AMX Elite) to those buttons with the variable text range of 500-504 & 510-515.
The border style is available through the TPDesign4 border-style drop-down list. Refer to theTPD4 Border
Styles by Name table on page 33 for more information.
^BPP Set or clear the protected page flip flag of a button. Zero clears the flag.
Syntax:
"'^BPP-<vt addr range>,<protected page flip flag value>'"
Variable:
• variable text address range = 1 - 4000.
• protected page flip flag value range = 0 - 4 (0 clears the flag).
Example:
SEND_COMMAND Device,"'^BPP-500,1'"
Sets the button to protected page flip flag 1 (sets it to password 1).
^BRD Set the border of a button state/states only if the specified border is not the same as the current border. The
border names are available through the TPDesign4 border-name drop-down list.
Syntax:
"'^BRD-<vt addr range>,<button states range>,<border name>'"
Variable:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and
2 = On state).
• border name = Refer toBorder Styles by Numbers table on page 33.
Example:
SEND_COMMAND Device,"'^BRD-500.504&510.515,1&2,Quad Line'"
Sets the border by name (Quad Line) to those buttons with the variable text range of 500-504 & 510-515.
Refer to theTPD4 Border Styles by Name table on page 33.