AMX MIO-R4 - Input Commands; Cal; Remote Setup Commands; Mut

Programming the Mio R-4
65
Mio Modero R-4 Remote
Input Commands
A device must first be defined in the NetLinx programming language with values for the Device: Port: System. In all
programming examples, Remote is used in place of these values.
Remote Setup Commands
A device must first be defined in the NetLinx programming language with values for the Device: Port: System (in all
programming examples, Panel is used in place of these values). These commands are case insensitive.
Remote Run Time Commands (Cont.)
TPAGEOFF Turn Off page tracking.
Syntax:
SEND_COMMAND <DEV>,"'TPAGEOFF'"
Example:
SEND_COMMAND Device,"'TPAGEOFF'"
Turns Off page tracking.
@VKB Popup the virtual keyboard.
Syntax:
SEND_COMMAND <DEV>,"'@VKB'"
Example:
SEND_COMMAND Device,"'@VKB'"
Pops-up the virtual keyboard.
WAKE Force the remote out of screen saver mode.
Syntax:
SEND_COMMAND <DEV>,"'WAKE'"
Example:
SEND_COMMAND Device,"'WAKE'"
Forces the remote out of the screen saver mode.
Input Commands
^CAL Put remote in calibration mode.
Syntax:
"'^CAL'"
Example:
SEND_COMMAND Device,"'^CAL'"
Puts the remote in calibration mode.
Remote Setup Commands
^MUT Set the remote mute state
Syntax:
SEND_COMMAND <DEV>,"'^MUT-<mute state>'"
Variables:
• mute state = 0 = Mute Off and 1 = Mute On.
Example:
SEND_COMMAND Device,"'^MUT-1'"
Sets the remote's master volume to mute.
@PWD Set the page flip password. @PWD sets the level 1 password only.
Syntax:
SEND_COMMAND <DEV>,"'@PWD-<page flip password>'"
Variables:
• page flip password = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Device,"'@PWD-Main'"
Sets the page flip password to 'Main'.