Initial Configuration
15
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
4. Select NetLinx Master under Platform Selection to indicate you are working with a NetLinx Master.
5. Select the Serial tab to view the serial options (FIG. 5).
6. On the Serial tab, set the COM port parameters (used to communicate to the NetLinx Master).
Default serial settings for NetLinx Masters are:
7. Click OK to close the Communication Settings dialog.
8. Note that the serial configuration is indicated in the Configuration text field (FIG. 6):
FIG. 4
Communication Settings dialog - Recent tab
FIG. 5 Communications Settings dialog - Serial tab
• Comm Port: COM 1
• Baud Rate: 38400
•Data Bits: 8
•Parity: None
•Stop Bits: 1
• Flow Control: None
To Next Page
Loading...
