WebConsole - System Options
48
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
NOTE: The currently selected device is also indicated in the Device field at the top of the page.
2. By default, all diagnostics are disabled (see FIG. 51). To enable diagnostic messages from this device, click on one of the Edit
buttons along the bottom of the Diagnostics Options table.
This opens the Edit Options window (FIG. 52), where you can select which Diagnostics messages to enable or disable for this
device.
FIG. 51
Select Diagnostics from within a selected Device’s Network Settings page
Click on Diagnostics from within the device’s
Network Settings page to enable/modify
diagnostics for that device
To Next Page
Loading...
