What to do if calibration is not working on AMX Touch Panel?
If calibration isn't working on your AMX Modero touch panel, it might need to be reset after a firmware update. Try cycling the power to the panel to establish a baseline calibration. Then, go to the Calibration page and reset the on-screen calibration.
Why AMX NXD-1000Vi doesn’t respond to my touches?
If your AMX Touch Panel isn’t responding to your touches, make sure to remove the protective laminate coating on the LCD before starting the calibration process. The protective cover can interfere with calibration because it presses on the entire LCD, preventing accurate calibration on specific crosshairs.
Why my AMX Touch Panel WEP isn’t working?
If your AMX Touch Panel WEP isn’t working, ensure the same default key is set on both the panel and the Access Point. For example, if your access point's default key 4 is 01:02:03:04:05, you must also set the Modero panel's key 4 to 01:02:03:04:05.
Why NetLinx Studio only detects one AMX Master?
If NetLinx Studio only detects one of your connected AMX Masters, it's because each Master is assigned a Device Address of 00000, and only one Master can be assigned to a specific System number. To work with multiple Masters, open separate instances of NetLinx Studio and assign each Master its own unique System value. For example, assign System #1 to an NXC-ME260/64 and System #2 to an NI-4000 using two open sessions of NetLinx Studio.
General| Brand | AMX |
|---|---|
| Model | NXD-1000Vi |
| Category | Touch Panel |
| Language | English |
To Next Page
