Analog Devices MAXREFDES106#

To Next Page

To Previous Page

MAXREFDES106# Health Sensor Platform 4.0

Figure 12. PC GUI Select Destination

Figure 13. PC GUI Select Start Menu Folder

Figure 14. PC GUI Select Additional Tasks

4. Then, click Finish in the ‘Ready to Install’ pop-up.

Main Page

Features1
General Description1
Table of Contents2
System Architecture4
Push Button Description5
Color Definitions for the Status LED5
Location Quality Definitions for the Location Finder LED6
Included Components6
Additional Components Required7
Updating the Firmware8
Updating the MAX32666 Host MCU Firmware (.Bin)8
Required Equipment8
Procedure8
Updating the MAX32674C Algo Hub Microcontroller Coprocessor Firmware (.Msbl)10
Installing the MAXREFDES106# Health Sensor Platform PC GUI12
Charge the Device and Run the MAXREFDES106# Health Sensor Platform PC GUI15
Orientation of the USB-C 7-Lead Electrode Cable to the MAXREFDES10618
Measurements19
Photoplethysmogram (PPG)19
Electrocardiogram (ECG)21
Bioimpedance (Bio-Z)24
Algorithms26
Impedance Cardiography (ICG)26
Bio-Impedance Analysis (BIA)32
Heart Rate (HR)34
Blood Oxygen Saturation (Spo 2 )37
Temperature Sensors39
PC GUI Tabs40
Location Finder Tab40
PLL Tab41
PPG Mode Tab43
PPG Settings Tab45
PPG Measurement Settings46
ECG Channel Tab49
ECG Mux Tab52
ECG Lead off Tab53
ECG RLD Tab55
Bioz Drive Tab57
Bioz Receive Tab59
Bioz Mux Tab61
Bioz Calibration Tab62
BIA Tab65
Temperature Tab66
Plots Tab67
Register Tab68
Data Logging70
Logging to a File70
Logging to Flash Memory70
Data Format for Logged Files73
Troubleshooting74
USB Device Not Recognized74
The USB Serial Device Associated with the MAXREFDES106# Does Not Show up as a COM Port in the Device Manager Ports Listing74
Drag and Drop Does Not Work: Updating the MAXDAP-TYPE-C Programmer74
Packet Drop Counts Seen in the PC GUI76
Confirm that the Bleuio Dongle Firmware Is Version 2.2.076
Updating the Bleuio Dongle Firmware to 2.2.078

Analog Devices MAXREFDES106#

Table of Contents