Figure 78. Wait for the Percent Complete Message to Finish and the MAXDAP-TYPE-C LED to Stop
Flashing
Once the flash is complete, the MAINTENANCE drive disappears, and a new DAPLINK drive appears in
a few moments. The programmer is now ready to be connected to the MAXREFDES106#.
Figure 79. DAPLINK Drive
Packet Drop Counts Seen in the PC GUI
If packet drop counts are seen when using the PC GUI, then verify that the BleuIO version is 2.2.0 or
higher.
Confirm that the BleuIO Dongle Firmware is Version 2.2.0+
1. The BleuIO dongle firmware must be updated to version 2.2.0 or higher. To confirm the BleuIO
dongle firmware version number, plug in the BleuIO dongle and wait a few minutes for the MS
Windows drivers to finish installing.
Figure 80. Wait for MS Windows to Install BleuIO Dongle Drivers
To Next Page
Loading...