Location Quality Definitions for the Location Finder LED
The ‘Location Finder’ algorithm is activated when the MAXREFDES106# is turned on with a single
short press of the push button. The location finder can also be started using the GUI. When started
with a button press, the status LED blinks green when a good location is found. Until that time,
the status LED displays the current status. See the ‘Location Finder GUI’ tab description for more
information on patch placement and how the location finder works.
Included Components
The MAXREFDES106# platform includes the following components:
MAXREFDES106# Board
■ MAX32674C with Embedded Heart Rate and Blood Oxygen Saturation (SpO
2
) Algorithms
■ MAX32666 Host Microcontroller with Integrated BLE 5.0 and Location Finder Algorithm
■ MAX86178 PPG, ECG, and BioZ Analog Front-End (AFE)
■ Osram SFH 7015 Red, IR LED
■ Two Photodiodes (VEMD8080)
■ ADXL367 3-Axis MEMS Accelerometer
■ 256MB Flash Memory (MX66U2G45GXRI00)
■ MAX20356 Power Management IC (PMIC)
■ Two MAX30210 Temperature Sensors with ±0.1°C Accuracy from +20°C to +50°C
■ Two Aluminum Contact Disks
■ Lumex RGB Status LED
■ Push Button
USB-C 7-Lead ECG, BioZ Snap Electrode Cable (7-Lead Electrode Cable)
3M Red Dot ECG Wet Electrodes (B01AME7YC0, 14 Pieces)
Rechargeable 190mAh Li-Po Battery (HPL402323-2C)
MAXDAP-TYPE-C Programming Adapter
USB Type-C™ Cable (USB-C)
USB Micro-B Cable (Micro-USB)
BleuIO BLE 5.0 USB Dongle
Two-Piece Snap-Fit 3D Printed Enclosure
3M Double-Sided Adhesive Tape (1577, 5 Pieces)
To Next Page
Loading...
Need help?
General