Angelo Po FX201E2 - Page 114

Copyright by Servizio Clienti ANGELO PO Spa
114
Remove the protecting plastic film before install the new display.
Put the display on the adjustable references down and right and move it on the centre of
the window panel.
Thread the block profile and secure it with nuts (do not over-tighten the nuts to avoid
damage to the display).
To remove the flat connection from the display plug, unlock the clip by rotating it as shown
in the picture. Remember to lock again the flat cable.
MANDARE IN
BATTUTA
PUSH TO THE
BOTTOM
POSIZIONE BLOCCATO
POSIZIONE SBLOCCATO
UNBLOCKED POSITION
BLOCKED POSITION