Anritsu ML2400A Series - Page 157

RFCAL Turn RF ref er ence cali bra tor ON or OFF CALI BRA TION
Syn tax: RFCAL <state>
state: ON or OFF
Re marks: Turns on or off the RF ref er ence cal i bra tor.
Query: RFCAL?
Re turned
String: RFCAL <state>
RGH Range Hold Sen sor
SEN SOR
Syn tax: RGH <s>[,<val>]
s: A or B
val: 0 to 5
(0 = AUTO)
Re marks: This func tion is used to tog gle a sen sor’s range hold off or on, to set a
spe cific range to be held, or to se lect AUTO rang ing. RGH sent with only
the sen sor pa ram e ter will tog gle the sen sor be tween hold ing the pres ent
op er at ing range and AUTO. If RGH is sent with sen sor and value pa -
ram e ters, the sen sor range mode will be set to the range value sent.
Query: RGH? <s>
Re turned
String: RGH <s>,<val>
RSBAUD RS232 Baud Rate
SYS TEM
Syn tax: RSBAUD <val>
val: 12,24,48,96,192 or 384 hun dred bits per sec ond
Re marks: Sets the RS232 Baud rate for the rear panel se rial port.
Query: RSBAUD?
Re turned
String: RSBAUD <val>
RSMODE RS232 Op er ating Mode
SYS TEM
Syn tax: RSMODE <s>
6-70 ML2400A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION