s: EXTCOM
SRCSWP
Re marks: EXTCOM = Ex ter nal com mu ni ca tion. GPIB com mands are sent and re -
ceived via an RS232 con nec tion.
SRCSWP = Source sweep. Con nected to a sweeper so up dates to the
sweep ers power of fre quen cies etc. are au to mat i cally up dated on the
ML2400A Se ries also.
Query: RSMODE?
Re turned
String: RSMODE <s>
SE CURE Se cure sys tem state
SYS TEM
Syn tax: SE CURE <state>
state: ON or OFF
Re marks: Normally when the sys tem is pow ered on the ML2400A Se ries re turns
to the state it was in when it was pow ered off. This in cludes all the off set
ta bles, cal i bra tion ad just val ues, etc.
If Se cure is set to ON, non-volatile mem ory is dis abled and all stored val -
ues are re set to the fac tory de faults when the sys tem is pow ered on. As
long as this com mand is ON, the sys tem will load the pre sets (see Ap pen -
dix A, Sec tion A-3 ) ev ery time it is turned ON.
Query: SE CURE?
Re turned
String: SE CURE <s>
SENMM Sen sor Meas ure ment mode
SEN SOR
Syn tax: SENMM <s>,<mode>
s: A or B
mode: DE FAULT (car rier wave)
MOD (modu lated av er age)
CUS TOM (user con fig ur able trig ger setup mode)
Re marks: Tells the sen sor the type of sig nal it is ex pect ing. This helps the sen sor
to take the best mea sure ments. If in CDMA mode, the query will re -
spond with “SENMM? <s>,CDMA.”
Query: SENMM? <s>
ML2400A OM 6-71
GPIB OPERATION ML24XXA NATIVE COMMANDS
To Next Page
Loading...
