Installation GT3000
22 IMGT30017EN
The Preventing the recirculation of hot air
Outside the cabinet
Prevent hot air recirculation outside the cabinet by leading the
outcoming hot air away from the area where the inlet air to the
cabinet is taken.
Possible solutions are listed below:
- gratings that guide air flow at the air inlet and outlet
- air inlet and outlet at different sides of the cabinet
- cool air inlet in the lower part of the front door, and an extra
exhaust fan on the roof of the cabinet.
Inside the cabinet
Prevent hot air circulation inside the cabinet with leak-proof air
baffles as showed on the diagram on the right side.
No gaskets are usually required.
Figure 3A.3.1.2 Typical mounting.
NOTA For IP54 version ask to
Technical department
Mounting Slot Locations IP54 Mounting Complete Bracket Move for Nema Mounting
Air outlet
Air inlet
Hot area
Air baffle plate
Cool area
To Next Page
Loading...