Answer Drives GT3000 - Control Section

GT300 Installation
IMGT30017EN 33
3A.5 Control section
Two control boards can be installed: “D” basic control board, “E” plus control board.
3A5.1 MICROPROCESSOR BASIC CONTROL BOARD
Figure 3A.5.1.A Microprocessor Basic Control Board
ON Reserved (SVGT200-470F)
JP2
OFF Reserved (SVGT0P3-166F)
It change O.C.
threshold
1-2 Reserved
JP3
3 2 1 2-3
Reserved (Default) Third phase for O.C. protection (GTA1  028)
JP8
OFF Reserved
JP13
OFF Reserved
JP14
ON Reserved
1-2 Connects TX232 to X3 for Keypad Advanced (default)
JP15
3 2 1 2-3 Connects I2C – clock to X3, only for future development
1-2 Connects RX232 to X3 for Keypad Advanced
JP16
3 2 1 2-3 Connects I2C – data to X3, only for future development
Serial link
ON Current input on XM1-16/17 (R=475 Ohms)
JP17
OFF Voltage input on XM1-16/17 (default)
ON Current input on XM1-14/15 (R=475 Ohms)
JP18
OFF Voltage input on XM1-14/15 (default)
ON Pull-up to 10V on XM1-15/16
JP19
OFF (default)
Analog input
ON At XM1-20 terminal, the supply (+5V) is available for encoder (default)
SW1 - 1
OFF External power supply 12-24V
ON Load resistor (121 Ohms) connected to channel A (line-driver encoder)
SW1 - 2
OFF
ON Load resistor (121 Ohms) connected to channel B (line-driver encoder)
SW1 – 3
OFF
Encoder
ON Load resistor (121 Ohms) connected to channel Z (line-driver encoder)
SW1 - 4
OFF
Board description:
U1: microprocessor
U37: FLASH memory
U7: EEPROM
U56: coprocessor
XM1: control terminal board
X5: synchronous interface (Fieldbus)
RL1, RL2: relays
K3: RS232 / 485HD serial connectors
K4/K5: expansion board connectors
KE1, KE2: encoder interface card
X3: Keypads connector
X7: Digital I/O expansion card (SIOVA)
K5
KE1
18 19
JP18
JP19
JP17
K4
PS4
JP14
DL1
KE2
U1
X7
X3
U37
U7
JP15
JP8
JP16
JP3
U56
JP13
K1
JP2
RL2
RL1
DISP4
U35
1 2
3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
20 21 22 23 24 25 26 27 28 29 30 31 32 33 34
XM1A
XM1B
TP1
SW1
K5
A B
ON
C D