Custom Output Routing
The Output Routing can be freely changed if you have a unique setup. For instance, if you wish to
listen to your DAW’s Software Outputs 3-4 and toggle between 3 different speaker sets, you can
manually route Software Output 3-4 to Hardware Outputs 1-2, 3-4, and 5-6. (as shown in the Routing
tab below)
To use Speaker Sets while monitoring through the low latency mixer, route Mixer 1 (or Mixer 2) to
hardware outputs as shown below.
Operation - Apogee Quartet User’s Guide
Version 1, September 2012 24
To Next Page
Loading...
