ARCBRO Stinger Series - Page 3

Service Support Spirit
Unique Solution WWW.ARCBRO.COM
3
3.2.2【F2】→MAN .............................................................................................................. 16
3.2.3【F3】→RE-BREAK ..................................................................................................... 16
3.2.4【F4】→VIEW .............................................................................................................. 16
3.2.5【F5】KERF .................................................................................................................. 17
3.2.7【F8】RETURN ............................................................................................................. 17
3.2.6【F6】OTHERS ............................................................................................................. 18
3.3. Automatic startup ................................................................................................................. 22
3.3.1 Cutting speed ................................................................................................................ 22
3.3.2 Automatic machining start.............................................................................................. 22
3.4. Adjustment of cutting position of automatic control ............................................................. 22
3.4.1 In the process of automatic processing, only the keystrokes effective: .......................... 22
3.4.2 Pause after the adjustment of position of the cutting ..................................................... 24
3.5. Original Path Return ............................................................................................................ 25
3.5.1 Return along original path.............................................................................................. 25
3.5.2 Return at G00(when reach a piercing point) .................................................................. 26
3.5.3 Operation after returned ................................................................................................. 26
3.5.4 Repeat the above operation procedure until the desired effect is achieved. ................... 26
3.5.5 To exit machining mode ................................................................................................ 26
3.5.6 Total row number and beginning row in return process ................................................ 26
3.6. Breakpoint Restoration Process ........................................................................................... 27
3.6.1 Breakpoint restoration .................................................................................................... 27
3.6.2 Attention: ....................................................................................................................... 28