Service Support Spirit
Unique Solution WWW.ARCBRO.COM
4.1.8【F3】OTHERS
Fig.4.4 OTHERS Interface
4.1.8.1【F1】MACH-0
【F1】MACH-0:【RETURN TO MACHINE ZERO】: It’s a constant position, usually in the lower
left corner of the machine
4.1.8.2【F2】BRAKE
When this function is selected, during the machining process, each cut length (set breakage
point. mm. See [Control] in [Parameter]), set a breakage point,
The length of the partition bridge (mm) (see [Control] in [Parameter]) is controlled by the
operator to continue cutting. Note: This function has been maintained until
Press this key to cancel the function.
4.1.8.3【F3】P-START and【F4】P-END
[F3] starting point, "F4" measuring the finish line, steel sheet processing calibration function
When the steel plate is placed on the material table, the steel plate may be inclined or the
steel plate needs to be rotated by an angle due to other reasons, and then this function can be
selected during processing.
To Next Page
Loading...