Service Support Spirit
Unique Solution WWW.ARCBRO.COM
5.1.6【F6】USB-
To transmit programs. This system supports to transmit programs with USB disk. Press [F6]
key to enter the lower level of menu, as shown below. ：
Fig. 5.2 Transmission menu of US USB disk
[F1] Input: to transmit program from USB disk to the machining program space.
[F2] output: to output the machining program to USB disk from the machining program space.
5.1.7【F7】VIEW
When you want to preview the currently selected program file processing by the graphics,
can press F7 key.
To Next Page
Loading...