Service Support Spirit
Unique Solution WWW.ARCBRO.COM
Fig. 7.2 Speed interface
Speed parameters include--
STARTUP---- System X, Y axles at the time of starting and stopping the speed (unit: mm or inches per/minute,
See control parameters, the same below).
TIMING(S)---- System by starting speed adjustment to the highest speed (the speed) during the process of
the time it takes. Unit: seconds.
CORNER ACCELER(S)---- In the process of add/deceleration, linear acceleration time is, usually slightly
smaller than adjusting time (about nine over ten). Big machine this value accounted for the proportion of
smaller.
HIGH SPEED---- The top speed for manual and execute commands G00 runtime (unit: MM or Inch/Min)..
MACHINING SPEED(S)-----The top machining speed in flame/plasma machining operation, in mm/min. or
inch/min.
RET ORIGIN SPEED ----- When the running direction changes between program segments and changing
angle exceeds this angle, the system will decelerate to the starting speed around the corner. This value is
normally set smaller when the system is comparatively heavier. In addition, such considerations as
machining speed and machine vibration should be taken as well, smaller value for worse vibration.
To Next Page
Loading...