93
ENGLISH
DETAILED CHANNEL SETTINGS
----------------------------------------------------
15 Confirm »Satellite Selection« by pressing
»
«, and press »
V
« or »
Λ
« to select the
satellite you want to scan.
16 Select »Scan Mode« with »
V
« or »
Λ
«.
Press »
<
«, »
>
for "Network" or "Full" selec-
tion.
17 Select »Scan Type« with »
V
« or »
Λ
«.
Press »
<
«, »
>
« to select »Free Channels
Only« for free channels only, »Encrypted
Channels Only« for encrypted channels or
»All« for all satellite channels.
18 Using »
V
« or »
Λ
« select »Store Type«.
Press »
<
«, »
>
to select "All" to search for
both "Digital Channels Only" for TV chan-
nels only and "Radio Channels Only" for
radio channels only.
19 Press »
a
« to return to the previous menu.
20 Select »Next« with »
V
« or »
Λ
« and press
»
« to confirm.
– »Automatic Scan« menu shall be dis-
played and the scan for TV stations will
start.
– Scanning may take several minutes
depending on the number of television
stations received.
Note:
7
If some of the frequencies are not stored
completely due the changes in satellite
parameters made by the broadcaster, it is
recommended to set the »Scan Mode« as
»Network«.
21 Press »
a
« to return to the previous menu,
press »
H
« to return to TV broadcast or
press »
T
« to return to Home menu.
Manual search for single satel-
lite connected digital television
stations
If a certain channel cannot be found with auto-
matic scan, you can scan it manually by manual
scan function. You must enter all parameters of
the channel correctly. You can obtain the current
transponder information from Teletext page,
satellite TVmagazines or internet.
Important:
7
If there is a direct cable connection from
your satellite antenna to the TV, if there is no
common satellite antenna switchboard, you
need to search for a single cable.
1 Press »
H
« to return to the TV mode.
2 Select »Source« with »
)
« and confirm with
»
«.
3 Select »satellite« and confirm with »
«.
4 Press »
)
« and select »Settings« with »
>
«
and confirm with »
« .
5 Confirm »Channels and Inputs« with »
«.
6 Select »Channels« and confirm with »
«.
– Channel menu shall be displayed.
7 Select »Satellite« with »
V
« and confirm with
»
« .
8 Confirm »Channel Installation Mode« with
»
«.
9 Select »Satellite (Standard)« with »
V
« or
»
Λ
« or if you are using an operator, select
»Satellite (Operator Mode)« and confirm
with »
«.
10 Press »
a
« to return to the previous menu.
11 Use »
V
« or »
Λ
« to select »Manual Satel-
lite Tuning« and confirm with »
« button.
12 Confirm »Current Satellite« with »
«.
– Manual Satellite Tuning menu shall be
displayed.
To Next Page
Loading...
