Areva MiCOM C232 - Page 88

6 Local Control Panel
(continued)
6-32
C232-302-401/402/403/404-603 / C232/EN M/A23
The password can be changed by the user at any time. The procedure for this change is
described below. The starting point is the factory-set password.
Control Step / Description Control
Action
Display
0 In the menu tree ‘Par/Conf/LOC’ select the
parameter ‘Password’.
Par/Conf/LOC
Password
********
1 Press the ENTER key. Eight asterisks
appear in the fourth line of the display.
Par/Conf/LOC
Password
********
********
2 Press the ‘left’, ’right’, ‘up’ and ’down’ keys
to enter the valid password. The display will
change as shown in the column on the right.
Par/Conf/LOC
Password
********
*
Par/Conf/LOC
Password
********
*
Par/Conf/LOC
Password
********
*
Par/Conf/LOC
Password
********
*
3 Now press the ENTER key. The LED
indicator labeled EDIT MODE will light up. The
third line shows an underscore character ( _ )
as the prompt for entering a new password.
Par/Conf/LOC
Password
_
4 Enter the new password, which in this
example is done by pressing the ‘up’ key
followed by the ‘down’ key.
Par/Conf/LOC
Password
*
Par/Conf/LOC
Password
**
5 Press the ENTER key again. Asterisks
appear in the third line, and a cursor
(underscore) in the fourth line prompts the user
to enter the new password again.
Par/Conf/LOC
Password
**
_