6 Local Control Panel
(continued)
C232-302-401/402/403/404-603 / C232/EN M/A23 6-33
Control Step / Description Control
Action
Display
6 Re-enter the password.
Par/Conf/LOC
Password
**
*
Par/Conf/LOC
Password
**
**
7a Press the ENTER key again. If the
password has been re-entered correctly, the
LED indicator labeled EDIT MODE goes out
and the display appears as shown on the right.
The new password is now valid.
Par/Conf/LOC
Password
********
7b If the password has been re-entered
incorrectly, the LED indicator labeled EDIT
MODE remains on and the display shown on
the right appears. The password needs to be
re-entered. It is also possible to cancel the
change in password by pressing the CLEAR
key (see Step 8).
Par/Conf/LOC
Password
**
_
8 The change in password can be canceled at
any time before Step 7 by pressing the CLEAR
key. If this is done, the original password
continues to be valid.
C
Par/Conf/LOC
Password
********
Operation from the local control panel without password protection is also possible. To
select this option, immediately press the ENTER key a second time in steps 4 and 6
without entering anything else. This will configure the local control panel without
password protection, and no control actions involving changes will be possible until the
global change-enabling function has been activated (see the section entitled ‘Change-
Enabling Function’).
To Next Page
Loading...