Arjo 2000 - After Mounting the Bathtub

22
After mounting the bathtub
1 Carry out water installation.
(See chapter “Water installation” )
2 Calibrate the thermostat mixer.
(See chapter “Calibration of the thermostat mixer P220”
)
(See chapter “Calibration of the thermostat mixer P300” ).
If you wish to adjust default settings, see Technical
Manual.
3 Refit the rear panel cover. (See fig. 1)
4-5: For systems with integrated dispensing/disinfection
only:
4 Place ArjoOil (ArjoSound), ArjoCare and ArjoClean
bottles in the top box and attach the suction units.
• ArjoClean (Disinfectant Cleanser). (See fig. 2)
Set the Disinfectant/Cleanser concentration, see sepa-
rate document Instructions for Use.
• ArjoCare (Shampoo & Body Wash). (See fig. 3)
• Arjo Oil or ArjoSound (Skin Conditioner & Bath Oil).
(See fig. 3)
5 Fasten the securing lock plate (included with optional
disinfection).
• Put the key lock end into hole cut out. (See fig. 4)
• Level the plate and fit the other end in the opposite side
of the top box. (See fig. 5)
• Turn the key for locking.
MIX
80
7
0
6
0
50
4
0
30
2
0
Fig. 1
Fig. 2
Fig. 3
MI
X
8
0
7
0
6
0
50
40
3
0
20
MI
X
80
70
6
0
50
40
30
2
0
Fig. 4
Fig. 5