Arris X5001 - Page 19

19
X5001 USER GUIDE - 501-3327100
TCP/IP conguraon for Windows 7, Windows 8, or Windows 10
Follow these steps to congure the Ethernet interface on a Windows 7, Windows 8, or
Windows 10 operang system.
1. Click the Start menu and type network and sharing into the Search box.
2. Select Network and Sharing Center when it appears.
3. Click Change adapter sengs from the le-side menu.
4. Right-click on your local area connecon icon and select Properes to open the
Properes window.
5. Select Internet Protocol Version 4 (TCP/IPv4) and click Properes to congure TCP/
IPv4.
Note: If your cable provider requires TCP/IP version 6, select Internet Protocol
Version 6 (TCP/IPv6) and click Properes to congure TCP/IPv6.
The TCP/IP properes window for the version you selected displays.
6. For either TCP/IPv4 or TCP/IPv6, select Obtain an IP address automacally and
Obtain DNS server address automacally, unless instructed otherwise by your
cable provider.
7. Click OK to accept the new sengs and close the Properes window. Then click
Close to back out of the remaining setup screens.
TCP/IP conguraon for macOS
Follow these steps to congure the Ethernet interface on a macOS operang system.
1. Open System Preferences, either by choosing System Preferences from the Apple
menu or by clicking the System Preferences icon in the dock.
2. Click the Network icon.
3. Choose Automac from the Locaon drop-down menu, and Built-in Ethernet from
the Show menu.
4. Choose the TCP/IP tab, if necessary.
If you are using TCP/IPv4, go to step 5.
f your cable provider requires TCP/IPv6, go to step 8.
5. Choose Using DHCP from the Congure IPv4 menu.
6. If necessary, click the Renew DHCP Lease buon.
7. Close the System Properes applicaon.
TCP/IPv4 conguraon is completed.
8. If you are using TCP/IPv6, click Congure IPv6 near the boom of the previous
window.
9. Choose Automacally from the Congure IPv6 drop-down menu and click OK.
10. Close the System Properes applicaon.
CONFIGURING THE GATEWAY (cont.)